UniLIGHT Night-Fly XSmall DIY-set

Sopii pieniin lennokkeihin joiden kärkiväli max. 1m

Pakkauksessa mukana kaksi siivenkärkeen kiinnitettävää valoa sekä pyrstöön kiinnitettävä valo.

Valokaluste valmistettu 1mm lasikuidusta

Voidaan kytkä suoraan 2S LiPo akkuun tai uniLIGHT ohjainyksikköön.

Valoteho: noin 550/400 lumene valkoinen

Paino: 3x6g ilman johtoja

Night-Fly XSmall DIY-set up to 1m

Name: Night-Fly XSmall DIY-set up to 1m
Brand: uniLight
SKU: NIGHT-XS-DIYSET

SKU: NIGHT-XS-DIYSET

59,00 €

Antal

Cheap DIY set for park, indoor and Shockflyer and most small styrofoam models with up to 1 meter span. The set consists of two wing blades for the wings and a tail balde for the tail and rear fuselage.

There are no mounting plates included. Optionally there is the safety connection set NIGHT-XS-CONRG.

uniLIGHT Night Blades

Compact size with maximum performance

Lowest impact on flight behavior

New cable and plugless installation

Optimized, adjustable cooling reflector

Reduced self-glare

5 sizes for all standards

especially for wings and symmetrical for the tail

Asymmetrical design for maximum ruggedness

Safety holder with position light available

large systems as cable and autonomous battery version
First, the enclosed, small contact plate is glued firmly into the edge of the wings, sides or elevator, preferably with good epoxy and optional pegs. Make sure that the writing on the contact plates is readable so that the polarity is correct. In the top view, right is always plus.

The connection cable is guided centrally within the surface to the fuselage. All Night Blades can simply be operated in parallel on a 2S LiPo battery or on any uniLIGHT lighting control. Pay attention to the permissible current load and sufficient battery capacity, a shutdown at deep discharge could be fatal at night!

For commissioning, the Night-Blade is simply placed on the mounting plate with the two screws and tightened, the electrical contact succeeds automatically. Make sure that the labels are always readable.

The reflector surfaces are bent once so that the largest possible part of the light emission is directed to the model. ATTENTION: the reflector surfaces harden and can only be bent a few times. Fix the glued surface before you align the surfaces by hand or a small pliers to prevent breakage of the splice.

After the flight, the Night Blades can be easily unscrewed and easily transported. There is no trace left of the night flight system.

Inga omdömen änBerätta vad du tycker. Var den första som lämnar ett omdöme.

Night-Fly XSmall DIY-set up to 1m

Description:

Assembly and operation:

Technical Data:

Delivery:

Liknande produkter